Northern Industrial Tools 4333D User Manual download pdf (Page 6)

6

7. Make sure cord is located so that it will

not be stepped on, tripped over, or other-

wise subjected to damage or stress.

8. An extension cord should not be used

unless absolutely necessary. Use of

improper extension cord could result in a

risk of fire and electric shock. If extension

cord must be used, make sure:

a. That pins on plug of extension cord

are the same number, size, and shape

as those of plug on charger;

b. That extension cord is properly wired

and in good electrical condition;

c. That wire size is at least as large as

the one specified in the table below.

9. Do not operate charger with damaged

cord or plug - replace them immediately.

10. Do not operate charger if it has received a

sharp blow, been dropped, or otherwise

damaged in any way; take it to a qualified

serviceman.

11. Do not disassemble charger or battery

cartridge; take it to a qualified serviceman

when service or repair is required, Incor-

rect reassembly may result in a risk of

electric shock or fire.

12. To reduce risk of electric shock, unplug

charger from outlet before attempting any

maintenance or cleaning. Turning off con-

trols will not reduce this risk.

13. The battery charger is not intended for

use by young children or infirm persons

without supervision.

14. Young children should be supervised to

ensure that they do not play with the bat-

tery charger.

15. If operating time has become excessively

shorter, stop operating immediately. It

may result in a risk of overheating, possi-

ble burns and even an explosion.

16. If electrolyte gets into your eyes, rinse

them out with clear water and seek medi-

cal attention right away. It may result in

loss of your eyesight.

ADDITIONAL SAFETY RULES FOR CHARGER &

BATTERY CARTRIDGE

1. Do not charge Battery Cartridge when

temperature is BELOW 10°C (50°F) or

ABOVE 40°C (104°F).

2. Do not attempt to use a step-up trans-

former, an engine generator or DC power

receptacle.

3. Do not allow anything to cover or clog the

charger vents.

4. Always cover the battery terminals with

the battery cover when the battery car-

tridge is not used.

5. Do not short the battery cartridge:

Table 1: RECOMMENDED MINIMUM AWG SIZE FOR EXTENSION CORDS FOR BATTERY CHARGERS

Length of Cord (Feet) 25 50 100 150

AWG Size of Cord 18 18 18 16

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Comments to this Manuals

No comments